Pioneer Premier PRS D1200M - car - amplifier

• Manufacturer: Pioneer
• Part number: PRS-D1200M
• Description: PRS amplifiers feature Left and Right independent signal circuitry that eliminates signal interference between the channels and achieves excellent channel separation throughout a wider frequency range. In the quest for optimal bass, Pioneer focused on the PRS amplifier's power handling. With a high-capacity, custom-made capacitor bank adapted to the power supply section, this amp supplies power with rock-solid stability, and does an excellent job of reproducing low-frequency sound. The PRS amplifier features this Linear Technology Corporation operational amplifier (OP AMP) used in high-end home audio amplifiers for its precise gain and sound linearity characteristics. The PRS-D1200M includes the OP AMP in its bass boost circuitry to prevent sound quality deterioration. The units are externally bridgeable and permit two separate amplifiers to be joined together as one, doubling the power to a single woofer or voice coil. Best of all, no special cable is required - a simple RCA cable and proper setting of the Sync mode will get this. Pioneer's proprietary Multi-Amplifier Synchronization System (MASS) technology allows one amplifier (the master) to control the settings of other amplifiers when two or more amps are “strapped” together. Especially important for multi-amplified systems, this powerful Pioneer technology eliminates the need to adjust each amplifier gain separately. For added flexibility, the variable crossover lets you set the levels at which higher-frequency signals will be filtered out, so that the remaining lower-frequency signals get sent to your sub(s). Where they belong. This optimizes your system's efficiency and delivers the best possible sound quality. You can adjust it continuously between 40 to 240Hz. So you're in the driver's seat going 65mph and you want to fine-tune the bass boost. But the amp's out of reach, way in the back. What are you supposed to do - pull over, get out, and run around to the trunk? That's why the PRS-D1200M comes with a wired bass remote. It's set at 50Hz, ideal for tuning in some more thump from your subwoofers. And because this is selectable bass boost, you can set the level at 0dB, 6dB, or 12dB, whichever sounds best to you.

• General

• Packaged Quantity 1
• Product Type Amplifier
• Recommended Use Car
• Width 11.9 in
• Depth 8.4 in
• Height 2.2 in
• Weight 7.7 lbs

• Audio System

• Response Bandwidth 10 - 240 Hz
• Signal-To-Noise Ratio 92 dB
• Max Output Power / Channel Qty 1200 Watts x 1
• Continuous Power / Channel Qty 600 Watts x 1
• Amplifier Output 1-channel
• Input Signal Voltage 0.4 - 6.5V
• Crossover Active crossover
• Low Pass Frequencies 40 - 240 Hz
• Bass Boost Frequency 50 Hz
• Bass Boost Gain 0 to +12dB
• Amplifier Class Class D
• Distortion Factor 0.5%
• Amplifier Output Details 400 Watt - 4 Ohm - 20 - 240 Hz - THD 1.0 % - 14.4V DC - 1 channel(s),
  600 Watt - 2 Ohm - At 100 Hz - THD 1.0 % - 14.4V DC - 1 channel(s)
• Additional Features Input level controls ,
  Subsonic filter

• Connections

• Connector Type Audio line-in ( RCA phono x 2 ),
  Remote Bass control

• Manufacturer Warranty

• Service & Support 2 years warranty
• Service & Support Details Limited warranty - Parts and labor - 2 years

See pricing

Manufacturer profile

Browse Pioneer products on Shopper.com

• Manufacturer:Pioneer
• Address:

  2265 E. 220th Street, Long Beach, CA 90810

• Phone: 1-800-421-1404

See pricing